How to differentiate policies by IP network in ISE??

[JustTakeTheFirstStep]

I want to create a policy per IP network in ISE.
When a device with a manual IP setting is connected to the switch,
You want ISE to apply different policies for each IP network.

Group_A: 10.1.10.0/24 -> A Policy -> A profile
Group_B: 10.1.20.0/24 -> B Policy -> B profile

Any ideas?

[marce1000]

                                                                          - You may find these informational :

             https://community.cisco.com/t5/network-access-control/adding-an-ise-rule-in-an-authorization-policy-set-to-permit/td-p/3815812

            https://community.cisco.com/t5/network-access-control/using-ip-address-subnet-as-an-authorization-rule-in-an-ise/td-p/3815820

  M.