03-28-2013 03:17 PM - edited 03-10-2019 08:14 PM
Hello folks,
I'm trying to use Network Access Manager module that comes with Anyconnect as dot1x supplicant. I had it downloaded to Windows PC and it shows that I'm connected to wired network. How would I configure it to use a particular set of dot1x credentials? I don't see it anywhere.
03-29-2013 01:39 AM
Hello,
Is this helpful?
http://www.cisco.com/en/US/docs/security/vpn_client/anyconnect/anyconnect30/administration/guide/ac04namconfig.html#wp1074333
Or there is anything else missing?
Regards,
Amjad
Sent from Cisco Technical Support iPad App
03-31-2013 06:16 PM
Please check the below link and follow the steps for the answer of the query:
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: