cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
319
Views
0
Helpful
3
Replies

ACS 5 Limited user account

alkabeer80
Beginner
Beginner

Hi, i have cisco ACS 5.2 and want to create user account for technician, with only certain commands.

how can i achieve this ?

thanks                  

1 Accepted Solution

Accepted Solutions

Hi,

That is possible of course.

This document (part of it) shows command authorization on acs 5.x

http://www.cisco.com/en/US/products/ps9911/products_configuration_example09186a0080bc8514.shtml#ade


HTH

Amjad
Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"

View solution in original post

3 Replies 3

Amjad Abdullah
Engager
Engager

Hi,

You can not do per-commadn authorization.

But You can assign some of the pre-defined roles to the admin.

check this:

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.3/user/guide/admin_admin.html#wp1068641

Reards,

Amjad

Rating useful replies is more useful than saying "Thank you"

Rating useful replies is more useful than saying "Thank you"

Hi Amjad,

I am looking for giving technician some commands, like configure IP address inside interface and enable it. I dont want him to login to ACS, i want him to login in to devices authenticated through acs and once he logged in he can only access the given commands.

I am not aware how to do it ?

thanks

Hi,

That is possible of course.

This document (part of it) shows command authorization on acs 5.x

http://www.cisco.com/en/US/products/ps9911/products_configuration_example09186a0080bc8514.shtml#ade


HTH

Amjad
Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers