Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1681
Views
5
Helpful
5
Replies

I am using ISE2.0 with HP Procurve switch 2920 which supports CoA.

Go to solution
anil-sudharsanan.valanparambil
Level 1
Level 1

‎01-04-2017 04:25 AM

I want know how to configure CoA attributes under network device profile .

Procurve does support port-bounce and Disconnect.

I want to know how can a CoA message can be send to NAD which puts the client into a quarantine vlan by this.

Is it possible to use CoA push, if so how can I send this manually.

1 Accepted Solution

Accepted Solutions

Go to solution
Jeffrey Jones
Level 5
Level 5

‎01-04-2017 12:05 PM

You have to create a new HP Device Profile, and also create all the HP attributes in the dictionary, the HP Port Bounce one is missing from the default profile because HP has not update the RFC since 2006.

View solution in original post

0 Helpful