cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
436
Views
0
Helpful
2
Replies

if i need policy set on Cisco ISE (2.4) up 1000 policy how i do this ?

Hi 

if i need policy set on Cisco ISE up 1000 policy how i do this ?

because maxmum policy set version 2.4 up to 200 policy set.

i have ise box 2 box, SNS 3595 and primary and standby NAD up to 8000+ and identity upto 1000+ users.

1 Accepted Solution

Accepted Solutions

Damien Miller
VIP Alumni
VIP Alumni
2.4 supports 1000 authentication policies, and 3200 authorization rules as per the scaling guide. I would question going down the route you are headed though as that sounds like a nightmare to manage.
https://community.cisco.com/t5/security-documents/ise-performance-amp-scale/ta-p/3642148

View solution in original post

2 Replies 2

Damien Miller
VIP Alumni
VIP Alumni
2.4 supports 1000 authentication policies, and 3200 authorization rules as per the scaling guide. I would question going down the route you are headed though as that sounds like a nightmare to manage.
https://community.cisco.com/t5/security-documents/ise-performance-amp-scale/ta-p/3642148

thank you Damien Miller

2.4 supports 1000 authentication policies, and 3200 authorization rules  So both policies is under of Policy Sets right .

i saw in doc about Maximum number of Policy Sets 2.4 support to 200 policy sets.

if i need Maximum number of Policy Sets 2.4 support to 500 . can i do it ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: