In Cisco ISE, Live logs appears but In Endpoint that stopped appearing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2024 01:03 AM
We are in ISE 3.2.0.542 patch 3. Suddenly when i added new switch and deployed ISE with monitor mode.
Live logs shows up device but Endpoint profile shows blank in it
and If i go to context visibility > endpoints. These endpoints arent present there. These wasnt the case few days back when any endpoint once configured with ISE appears in live logs first and then same
- Labels:
-
Security Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2024 05:23 AM
check you may be effecting with Bug : (suggest to raise an TAC Case ?)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2024 05:25 AM
Can you share screenshots
MHM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-21-2024 06:48 AM
Are those sessions you see in live logs failed sessions? Endpoint profiles would not show up for the failed sessions. If that is not the case probably I would try to reset the context visibility database. You can do so by issuing the command "application configure ise" and then select the number of the "Reset Context Visibility" which should be number 20.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-25-2024 06:16 AM
this worked for me!
TY Aref
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2024 06:30 AM
- We are in ISE 3.2.0.542 patch 3. Suddenly when i added new switch and deployed ISE with monitor mode.
Live logs shows up device but Endpoint profile shows blank in it. ideally first it used to profile something atleast based on mac OUI or start digits or unknow now its completeely blank
and If i go to context visibility > endpoints. These endpoints arent present there. These wasnt the case few days back when any endpoint once configured with ISE appears in live logs first and then same appears in endpoints too but now its not the case and need help
we even tried context synch by no 21 and also later reloaded the Admin node but didnt solve issue
And there is no delay in live logs they appear immediately
And irrespective if auth fail or pass the end point gets registered and appears before now it doesnt ...
So still looking for solution..tried reload of Admin node didnt fix that as well

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2024 03:38 PM
Were you able to get this resolved? If so, what did you do?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-22-2024 08:00 AM
Can you please try to remove an endpoint manually and see if that makes any difference? if not, I would recommend raising a TAC for this.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-23-2025 12:32 AM
Good morning,
even with a restart of the context visibility the error and missing endpoints remains.
ISE 3.3 patch 4.5
