Initial deployment ISE

[elmiguelo]

     Good day,

I am totally new whith ISE solution, i have this concern, in the training section i see that the configuration in the ISE, just one interface is configured just the management interface, so, i see the appliance has 6 inrfaces, my question is, the other 5 interfaces what are these for

may is a stupid question, but as i say i am totally new, and i am the guy who has to installa the applaiance on cutomers

[paul · Accepted solution]

You could use the other interfaces to separate RADIUS/TACACS from management or add an interface out into a DMZ for guest portals.

I typically delete all 6 E1000 interfaces and add back in one VMXNET3 interface.