Is ISE agent required for PC when configuring monitor mode in switches?

[getaway51]

Hi,

Do I need to use agent in PC when configuring monitor mode in switches? 

[Francesco Molino]

Hi

I believe your taking about implementing ise for dot1x in monitor mode.
The answer is no need of any agent on your device, just use the native supplicant.
Below an official doc for this mode:
https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/design-zone-security/howto_21_monitor_mode_deployment_guide.pdf

[getaway51]

Hi,

Many thanks for yr advise. May I know where the traffic of "monitor mode" will in processed? which policy set in ISE will determine traffic of "monitor mode"? or how can i determine in ISE wht to do with these "monitor mode" traffic?