ise 2.1 radius authentication guide

[mulhollandm]

folks

i want to authentication ssl vpn users against my ise box

i want to configure users, put them into groups and then allocate an ip address based on their group membership after successful authentication

has anyone a configuration guide or a link to one for this type of setup

I'd be grateful for any links or examples

thanks to anyone taking the time to reply - much appreciated 

 

[Rahul Govindan]

Could not find a Cisco config example or guide to match what you were looking for. But there was a really nice article on petenetlive which had most of what you would need:

www.petenetlive.com/KB/Article/0001155

You can also look at the labminutes video on youtube with ISE1.2:

https://www.youtube.com/watch?v=HcMf3q_lmYo

Hope these help.

[mulhollandm]

rahul

thanks for your help and contribution, its greatly appreciated

I'd seen these in my own searching but haven't gave them the attention the most likely deserve

i'll have another look at them

many thanks for your help