ISE 2.2 Anyone seeing Conditions disappear under TACACS Authorization policy?

[jkozlov]

I am trying to add conditions (equipment related) to my TACACS Authorization policy and it is there before I save the policy, but when after it is done saving, it disappears and it not there anymore.  I edit the rule and the condition is gone. 

[hslai]

Were you able to add it at all? Which browser are you using? Any particular dictionaries impacted or all?

At times, I run into similar even in previous releases. As a practice, I usually open the condition box again after any edits before saving the whole policy set.

[jkozlov]

What I found is that I was trying to use POLICY ELEMENTS>NETWORK CONDITIONS>DEVICE NETWORK CONDITIONS, which from a network person perspective would have made sense, but after some more reading found that I actually had to use POLICY ELEMENTS>CONDITIONS>AUTHORIZATION SIMPLE CONDITIONS, create each condition there and tie it to is respective Network Device Group.  This box does not seem to be that "intuitive" for someone who is just trying to build the ACS side of this appliance for usage.  But figured it out.

[hslai · Accepted solution]

If ISE upgraded from a previous release, you might have run into CSCvd14926