ISE 2.2 with Hyper-V

[ymadheka]

Hi Folks,

Has anyone successfully deployed ISE 2.2 on Microsoft Hyper-V, seems that after installing ISE v2.2 and subsequent reboot only blank screen is displayed with no further progress even after multiple tries of installation.

Kindly advise for any resolutions if faced with same issue.

Thanks & Regards,

Yogesh Madhekar

[ldanny]

Have you followed Microsoft Hyper-V requirements

https://www.cisco.com/c/en/us/td/docs/security/ise/2-2/install_guide/b_ise_InstallationGuide22/b_ise_InstallationGuide22_chapter_01.html#hypervrequirements

Danny

[ymadheka]

Yes the same article has been followed.

[hslai]

If this is for a customer setup, please open a TAC case and escalate to our ESC team. This seems varied from case to case.

[hslai]

If this is for lab, I would suggest to use VMware. There is an on-going ESC case on Hyper-V Generation 2 VM vs Generation 1.