cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3476
Views
5
Helpful
2
Replies

ISE 2.6 run show run cli, it hangs at 'generating configuration

lilianamartinez
Level 1
Level 1

I have a client running ISE 2.6.0.156 Patch 7 . When we run show run , it hangs at 'generating configuration.' It works before , and all applications are running.

1 Accepted Solution

Accepted Solutions

moazizuddin
Level 1
Level 1

Found an old post where this was happening in ISE 1.3 and 1.4.

 

Fix was to disable cdp on GigabitEthernet 0

(no cdp run GigabitEthernet 0)

 

I was able to disable it temporarily, 'show run' starting working. Re-enabled CDP on GigabitEthernet 0, and 'show run' was still working.

 

View solution in original post

2 Replies 2

marce1000
VIP
VIP

 

- show application status ise (if not yet done), also look for performance bottlenecks on targeted host.

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

moazizuddin
Level 1
Level 1

Found an old post where this was happening in ISE 1.3 and 1.4.

 

Fix was to disable cdp on GigabitEthernet 0

(no cdp run GigabitEthernet 0)

 

I was able to disable it temporarily, 'show run' starting working. Re-enabled CDP on GigabitEthernet 0, and 'show run' was still working.

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: