Solved: Re: ISE 2.6 run show run cli, it hangs at 'generating configuration

lilianamartinez · ‎09-24-2020

I have a client running ISE 2.6.0.156 Patch 7 . When we run show run , it hangs at 'generating configuration.' It works before , and all applications are running.

moazizuddin · ‎09-25-2020

Found an old post where this was happening in ISE 1.3 and 1.4.

Fix was to disable cdp on GigabitEthernet 0

(no cdp run GigabitEthernet 0)

I was able to disable it temporarily, 'show run' starting working. Re-enabled CDP on GigabitEthernet 0, and 'show run' was still working.

View solution in original post

marce1000 · ‎09-25-2020

- show application status ise (if not yet done), also look for performance bottlenecks on targeted host.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

moazizuddin · ‎09-25-2020

Found an old post where this was happening in ISE 1.3 and 1.4.

Fix was to disable cdp on GigabitEthernet 0

(no cdp run GigabitEthernet 0)

I was able to disable it temporarily, 'show run' starting working. Re-enabled CDP on GigabitEthernet 0, and 'show run' was still working.