05-05-2022 08:59 AM
I have a new ISE 2.7 on VMware and I'm trying to connect to the remote repository to get the backup configuration. The challenge is after setting up the Repo using GUI I get error message "xx-ise-02/admin# show repository SFTP-REPO
% Error: Repository SFTP-REPO could not be accessed. In case Backup was Restored on different setup, Please reconfigure the repository passwords (expected behaviour).
% Failure occurred during request" when I try and validate.
I have added the cryto host keys and even went to the extend of deleting everything and recreating but to no avail.
Any ideas would be welcome
Thanks,
Syd
Solved! Go to Solution.
05-06-2022 06:19 AM
I have resolved this issue and it was caused by the username and password we had been provided which did not match with what was on the remote repository.
05-05-2022 09:21 AM
- On CLI use : debug transfer 7 , then run the command show repository SFTP-REPO , again : post output here.
M.
04-30-2024 04:04 AM
05-06-2022 06:19 AM
I have resolved this issue and it was caused by the username and password we had been provided which did not match with what was on the remote repository.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide