10-27-2015 03:25 AM - edited 03-10-2019 11:11 PM
Hi ,
i'm not great in the virtual world , i need a help in my setup please .
i have ise 1.3 and windows 7 , both are VM on esxi i need to test some features like CWA, Client provisioning and posture assessment on the windows 7 .
I don't know how to place a cisco switch (physical or nexus 1000v) and connect the windows vm on it so i can start my tests.
I know a lot of people have been doing that but i could not find a a clear instruction on how to complete the configuration .
Thanks in advance.
KO
Solved! Go to Solution.
10-27-2015 07:01 AM
Hi , i'm not great in the virtual world , i need a help in my setup please . i have ise 1.3 and windows 7 , both are VM on esxi i need to test some features like CWA, Client provisioning and posture assessment on the windows 7 . I don't know how to place a cisco switch (physical or nexus 1000v) and connect the windows vm on it so i can start my tests. I know a lot of people have been doing that but i could not find a a clear instruction on how to complete the configuration . Thanks in advance. KO
Hi KO,
Try configuring both the devices in same vlan first and test your policies.
Just add simple vlan on switch with number 10 or anything and assign both the connected ports or virtual adapter on vlan 10 for connectivity.
Hope it Helps..
-GI
Rate if it Helps
11-06-2015 04:54 AM
So I have an HP DL360 G5 that has 2 nics and runs ESXi.
I have one NIC trunked and used for different server vlans.
I have one NIC on an access vlan that is protected by dot1x.
I have dot1x on the port for the access vlan and that does auths as if it was a normal PC connected. Just make sure if you have more than 1 user VM attached you set the port to multi-auth so multiple authentications can happen on the same port
10-27-2015 07:01 AM
Hi , i'm not great in the virtual world , i need a help in my setup please . i have ise 1.3 and windows 7 , both are VM on esxi i need to test some features like CWA, Client provisioning and posture assessment on the windows 7 . I don't know how to place a cisco switch (physical or nexus 1000v) and connect the windows vm on it so i can start my tests. I know a lot of people have been doing that but i could not find a a clear instruction on how to complete the configuration . Thanks in advance. KO
Hi KO,
Try configuring both the devices in same vlan first and test your policies.
Just add simple vlan on switch with number 10 or anything and assign both the connected ports or virtual adapter on vlan 10 for connectivity.
Hope it Helps..
-GI
Rate if it Helps
11-06-2015 04:54 AM
So I have an HP DL360 G5 that has 2 nics and runs ESXi.
I have one NIC trunked and used for different server vlans.
I have one NIC on an access vlan that is protected by dot1x.
I have dot1x on the port for the access vlan and that does auths as if it was a normal PC connected. Just make sure if you have more than 1 user VM attached you set the port to multi-auth so multiple authentications can happen on the same port
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide