- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-24-2022 01:19 AM
I want to make a policy authentication for the assigned username list. I pulled the username list from MS Active Directory. I just require the Username that I specify; I do not require any other Usernames.
For example, there are 1000 total usernames in MS Active Directory, but I only require 500 of them, as defined.
- ----- Allow list For Authen ----
- username : Dummy1
- username : Dummy21
- username : Dummy30
- username : Dummy42
- username : Dummy82
The remaining usernames cannot be authenticated.
How can policy authentication be created?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-24-2022 01:43 AM
Then I suggest is create a new group and add that 500 users to a new Group and using that group in ISE is the best option I see here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-24-2022 01:43 AM
Then I suggest is create a new group and add that 500 users to a new Group and using that group in ISE is the best option I see here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-24-2022 04:40 AM
I am assuming you are using 802.1x for authentication. Are you using certificate authentication? If so, is there any distinct attribute that would identify these 500 users and not the others? Example, AD Groups, OU, or Location?
