- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2015 06:35 AM - edited 03-10-2019 11:21 PM
Hello everybody ,
We have ISE 1.4 , sometimes I can't see ip adress at endpoint list for a endpoint when I select endpoint , I see ip adress at report or I have two devices for same ip adress (old and new endpoints) , Mac adresses are different . How can I update endpoint list?
Regards..
Solved! Go to Solution.
- Labels:
-
AAA
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2015 11:57 AM
ISE retains the endpoint information based on the latest information that it has seen/collected for that endpoint. The endpoint information, such as IP address, should update once the deice reconnects to the network. If the old device does not connect on the network again, ISE will retain the latest known information or purge the device (if purging is enabled).
I hope this helps!
Thank you for rating helpful posts!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-28-2015 11:57 AM
ISE retains the endpoint information based on the latest information that it has seen/collected for that endpoint. The endpoint information, such as IP address, should update once the deice reconnects to the network. If the old device does not connect on the network again, ISE will retain the latest known information or purge the device (if purging is enabled).
I hope this helps!
Thank you for rating helpful posts!
