08-03-2017 08:31 AM - edited 03-11-2019 12:54 AM
I am unable to add a device filter to a Device Admin Policy Set.
I add my AD Group, then add my condition to use a Device Filter (Device Network Condition) that has all the IPs I am filtering on. but it always dissapears when I save it.
Solved! Go to Solution.
08-03-2017 04:26 PM
Suggest to install 2.2 patch 2 which is available on CCO
This has a fix for this issue which was under following CDETS: CSCvd14926
08-03-2017 04:26 PM
Suggest to install 2.2 patch 2 which is available on CCO
This has a fix for this issue which was under following CDETS: CSCvd14926
08-04-2017 12:59 AM
Will this patch fix the issue?
The fix you posted is a) Not a fix and b) It doesnt work, when you choose custom condition, you cannot select Network Conditions.
Thanks for the reply though
08-04-2017 04:00 AM
You say it doesn't work. Have you installed 2.2 patch 2 and tested it?
08-04-2017 04:03 AM
I didnt no, I couldnt at the time, I was trying to use the workaround which doesnt work!
Anyway, I have now added Patch 2 and I can save the device filter policy.
Thanks for replying and assisting.
08-04-2017 11:11 AM
Patch 2 still doesnt fix the problem. and make it even worse!!!. Network Condition doesn't exist from Policy GUI anymore:
if you want to select Network Condition from existing library, the Network Condition category is missing.
08-04-2017 11:41 PM
It worked for me, you have to add Custom Attribute not condition from library.
08-05-2017 08:05 PM
but we cannot save it in Library or read existing one from Library we already created in P1......
08-06-2017 07:34 AM
Not sure why you mention a P1?
All I can say is, after the Patch I can create a device policy set, add my AD Group and also add a custom attribute which I can see my network condtion listed.
08-07-2017 07:52 PM
In P1 at least we can select Network Condition from Library. Once upgraded to P2, this option is gone from Library .
08-08-2017 12:53 AM
It wont be in the Library, unless you save it to the library, Just add a custom attribute once you have added your AD group or Users.
08-04-2017 11:13 AM
P2 didnt fix the problem. After we upgraded from 2.1P3 to 2.2 P2.
we even couldnt select Network Condition from existing library. NC is missing during P1 to P2 upgrading.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: