cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1547
Views
5
Helpful
11
Replies

ISE Network Conditions - ISE 2.2.470 Bug CSCvd92012

James Davies
Beginner
Beginner

I am unable to add a device filter to a Device Admin Policy Set.

I add my AD Group, then add my condition to use a Device Filter (Device Network Condition) that has all the IPs I am filtering on. but it always dissapears when I save it.

Bug CSCvd92012 is useless as it says to create a custom condition, but the option is not there to create or select your filter?
Thanks
1 Accepted Solution

Accepted Solutions

jrabinow
Rising star
Rising star

Suggest to install 2.2 patch 2 which is available on CCO

This has a fix for this issue which was under following CDETS: CSCvd14926

View solution in original post

11 Replies 11

jrabinow
Rising star
Rising star

Suggest to install 2.2 patch 2 which is available on CCO

This has a fix for this issue which was under following CDETS: CSCvd14926

Will this patch fix the issue?

The fix you posted is a) Not  a fix and b) It doesnt work, when you choose custom condition, you cannot select Network Conditions.

Thanks for the reply though

You say it doesn't work. Have you installed 2.2 patch 2 and tested it?

I didnt no, I couldnt at the time, I was trying to use the workaround which doesnt work!

Anyway, I have now added Patch 2 and I can save the device filter policy.

Thanks for replying and assisting.