Hello
Has anyone managed to get SNMPv3 traps working in ISE 2.7 patch 3?
I don't see any SNMPv3 traps sent out when I restart services, or when I set the disk threshold very high (99% free).
However, when I add an SNMP v2c entry, then all of a sudden I see SNMP v2 traps. But no SNMP v3 traps.
I have tried the usual application restart/reboot etc. No luck.
The SNMPv3 MIB is working well (ISE SNMP MIB successfully being polled by Solarwinds using SNMP v3)
The config is below. The "0x1" in the SNMP v3 trap config is the EngineID of the remote receiver (Solarwinds)
I set the disk threshold artifically low at 99% just to cause ISE to send a trap - it's a handy way to force ISE to send a trap.
snmp-server enable
snmp-server contact "Joe Bloggs"
snmp-server location "In some hypervisor somewhere"
snmp-server trap dskThresholdLimit "99"
snmp-server host 192.168.1.2 version 3 NMS 0x1 hash ********** **********
snmp-server host 192.168.1.2 version 2c public
snmp-server engineID **********
snmp-server user NMS v3 hash ********** **********
