06-30-2017 10:49 AM - edited 03-11-2019 12:49 AM
We just purchased ISE. I deployed the OVA, but it doesn't ask me for a default CLI password any time. I can't find what the default CLI password is supposed to be, so I can finish setting the software up. I have tried all the combinations I have seen online, none work. This is a VMWare installation.
Thanks.
Solved! Go to Solution.
06-30-2017 04:32 PM
Once deployed
Powerup the VM and on the console port type username =setup and password = setup
This will will start the install and prompt you to configure this VM and root/admin passwords. Follow the prompts until it completes the configuration and it will reboot the VM to complte the configuration. Once rebooted then loginto Web and conmplete the rest of the configuration.
Hope this helps , Rate the post
Thanks
Shaheen
06-30-2017 04:32 PM
Once deployed
Powerup the VM and on the console port type username =setup and password = setup
This will will start the install and prompt you to configure this VM and root/admin passwords. Follow the prompts until it completes the configuration and it will reboot the VM to complte the configuration. Once rebooted then loginto Web and conmplete the rest of the configuration.
Hope this helps , Rate the post
Thanks
Shaheen
07-03-2017 07:21 AM
Shaheen,
Thanks for the info, that was it. I was able to finish setup and get registered with our Smart account. Thanks,
Chris.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide