ISE Profiler Feed Service Update

[Ali Hashemi]

Hey,

I have tried couple of times so far to update the ISE profiler feed service and it always says " it has been successfully update" after 2 seconds; however, last update feed show 2013-05. (see attached) I'm running ISE 1.2 with all patches installed (1,2,3,4,5,6,7) .Does anyone have some idea about this issue? I'd really like to update the OUI database for the new devices and seems to be this is the only automatic way!

Thanks,

Ali

[kaaftab]

Cisco update the the OUI as they become available but if you are facing issue regarding specific OUI do mention or you can custom define that device for profiling (for short term solution)

Also confirm this information.

[Naveen Kumar]

By default, the profiler feed service is disabled, and it requires an Advanced license to enable the service. When you enable the profiler feed service, Cisco ISE downloads the feed service policies and OUI database updates every day at 1:00 A.M of the local Cisco ISE server time zone. Cisco ISE automatically applies these downloaded feed server policies, which also stores the set of changes so that you can revert these changes back to the previous state. When you revert from the set of changes that you last applied, endpoint profiling policies that are newly added are removed and endpoint profiling policies that are updated are reverted to the previous state. In addition, the profiler feed service is automatically disabled.

[Venkatesh Attuluri]

if you are facing any error with feed server you can get the report from Operations Audit report.