ISE profiling and device tracking configuration in switch 2960X

[mnkojima]

Hello

I am configuring ISE profiling and a switch 2960x IOS 15.2. I read that device tracking must be enabled on the switch.

My question is: do I need to configure only the global command "ip device tracking probe auto-source" or do I need also to configure at each switchport the command "ip device tracking maximum"?

Thank you

Marcos

[Greg Gibbs · Accepted solution]

Please see the configuration examples in the ISE Secure Wired Access Prescriptive Deployment Guide. These are the validated and recommended configurations for both Legacy IBNS and IBNS 2.0.