mnkojima
Level 1
Level 1
Member since ‎11-23-2005
‎06-25-2025

User Statistics

  • 133 Posts
  • 2 Solutions
  • 33 Helpful votes Given
  • 10 Helpful votes Received

User Activity

Hello in our environment we are using ISE 3.1 and Meraki access points. We are implementing posture. Sometimes clients get disconnected during working hours, after posture lease expires and when roaming occurs. Analyzing DART logs, we see the message...
Hello we have an wireless environment with Meraki access points and we are implementing posture. Clients connect successfully to the network, however, they change to 'unknown' status with no apparent reason. After a manual re-scan, client is placed a...
Hello We have an C9800-CL, and we want one SSID to be "Flex" and another one "central switched". Is that possible? If so, what mode do we need to configure the AP? Thank you Marcos
Hello we are implementing ISE with posture in our environment. We do not want to use the client provisioning portal, we will manually install anyconnect and posture module at our laptops. I have not been able to find a good document on how to do that...
Hello we have a C9800-CL and 9115 access points in flex mode. When we install wireless at a new site, we always need to wait for the first access point to download the firmware from the wlc at the data center and that takes time, because of the WAN l...
Community Statistics
Member Since ‎11-23-2005 11:13 AM
Date Last Visited ‎06-25-2025 01:04 PM
Posts 133
Total Helpful Votes Received 10
Helpful Votes From