ISE SNMP v3 write access and ssh

[Junyx sen]

Hi, All

Anyone knows the the following settings for cisco ISE?

1. SSH - is it SSHv1 or V2

2. SNMP - when using snmp v3, is the write access is disabled or enabled.

Thank you!

Junyx

[M. Wisely]

SSH V2

You can't make changes to ISE via SNMP. Even with v2c you can only create a read only community.

[Junyx sen]

Hi, Martin

Thanks for your feedback.

So is it safe to say that the SNMPv3 write access in cisco ISE is disable by default?

Thanks.

[M. Wisely]

An easy way to show whether snmp is enabled is in the cli:

show run | include snmp

If you don't see any snmp commands, snmp isn't enabled.

[Junyx sen]

Hi, Martin

this is more on an audit for our cisco ISE device, since there is no settings for read and write, now the auditor is asking what is the snmp default access. Is it Read only or Read write?

I cannot see any settings or commands to verify these info.

Hope you can advise.

Thanks you