Live log not getting populated into ISE

[rohitbhanu009]

Hi,

I can not see live log in to the ISE servers under operation TAB.

I checked below points

ISE application status

ISE Servers disk utilization

all looks good.

Thanks

Rohit

[Rahul Govindan]

Are you not seeing the page itself? I have seen issues where the Live Log page does not show if you have Ad Blockers enabled on your browser.

[rohitbhanu009]

Thanks for the reply Rahul,

We are able to see the oage. I have attached the file for your reference.

[Rahul Govindan]

Do you have a firewall between your ISE nodes? If you do, you might have to open all the ports documented in the link below for the Admin node to be able to read the live logs:

http://www.cisco.com/c/en/us/td/docs/security/ise/2-2/install_guide/b_ise_InstallationGuide22/b_ise_InstallationGuide22_chapter_0110.html#ID-1420-00000088

[rohitbhanu009]

Hi Rahul,

Earlier we were getting log and its stop working from 22nd Of this month earlier we were getting log without any issue.

[Rahul Govindan]

That is strange. I would recommend opening a TAC case if this was a working setup and nothing has changed. Unfortunately, I have not seen such an issue happen before.

[rohitbhanu009]

Ok. I`m opening the TAC case now.

[Junyx sen]

We are having the same issue. 

Was your issue resolved?