Meraki Z1 and Z3 ISE Capabilites

[sfrisby]

Which category does the Meraki X1 and X3 Teleworker devices fall into w/ respect to the compatibility Matrix on page 5 of this document..

How To: Integrate Meraki Networks with ISE

Assuming the X1 and X3 fall into the MX class  -seeking confirmation.

Message was edited by: Hsing-Tsu Lai Corrected the models in the title.

[hslai]

Did you mean Z1 and Z3 as in Meraki Cloud Managed Security & SD-WAN > appliances#models? Since the model names do not carry MX and Tim is not immediately available, I would suggest you to check with Cisco Meraki directly. My guess is not as the teleworker units are usually not as feature-rich.

[sfrisby]

Yes .. I meant Z1 and Z3

[scamarda · Accepted solution]

Only the Z3 supports 802.1x.  Limited to hybrid - MAB and Dot1X.  No CoA support. 

https://documentation.meraki.com/MX-Z/Access_Control_and_Splash_Page/MX_Access_Policies_(802.1X)#Hybrid