cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1738
Views
10
Helpful
1
Replies

More interfaces enabled before Posturing

Hello, 

 

I have ISE with posturing with NAM agent Cisco AnyConnect

 

I would like to ask if it is possible to allow an ethernet card enabled, apart form the virtual of Cisco AnyConnect.

 

Is there any documentation?

 

Thanks and regards, 

Konstantinos

 

 

1 Accepted Solution

Accepted Solutions

hslai
Cisco Employee
Cisco Employee

AnyConnect NAM is for 802.1X auth but not for posture. By default, all supported interfaces are controlled by NAM. If needed, you may remove an interface from NAM control by clearing the checkbox in the interface properties page.

View solution in original post

1 Reply 1

hslai
Cisco Employee
Cisco Employee

AnyConnect NAM is for 802.1X auth but not for posture. By default, all supported interfaces are controlled by NAM. If needed, you may remove an interface from NAM control by clearing the checkbox in the interface properties page.