on SNS 3700, how to link ISE application interface to a different port

[M.G.1]

Hello experts,

By default on a Cisco SNS 3700 Series Appliance, below mapping exists.

• LAN1 (linked to Cisco ISE GigabitEthernet 0 interface)

• LAN2 (linked to Cisco ISE GigabitEthernet 1 interface)

The switch we are connecting to does not have any copper port, therefore I need to use Riser1 module on the appliance.

How can I change the above mapped interfaces to:

• GigabitEthernet 2 interface should be linked to Cisco ISE GigabitEthernet 0 interface

• GigabitEthernet 3 interface should be linked to Cisco ISE GigabitEthernet 1 interface)

Thank you.

M.G.

[balaji.bandi]

Not that i am aware it is restricted to Interface i guess (i have used standard deployment all the time)

But i do not see any specific Interface information on the installation guide :

Other than - 

• Cisco ISE management is restricted to Gigabit Ethernet 0.

https://www.cisco.com/c/en/us/td/docs/security/ise/3-2/install_guide/b_ise_installationGuide32/b_ise_InstallationGuide32_chapter_7.html

[Marvin Rhoads]

As noted by @balaji.bandi, the ISE management GUI must always use LAN 1 / GigabitEthernet 0. It cannot be mapped or changed to any other physical interface on the appliance.