03-17-2016 08:48 AM
Hi,
I am installing ISE 1.4 (with Patch 6) in my customer network. We have 2 PAN and 2 MnT with 10-12 PSNs. While configuring PAN Auto Failover, I set the Primary MnT as Primary health check node and Secondary MnT as Secondary health check node.
When I stopped the ISE services in Primary PAN node, the Auto Failover didn't happen and I got the message that PAN Secondary rejected to take over auto failover as Primary PAN is still available.
When I reloaded Primary PAN node, then the Auto PAN Failover worked fine.
I wanted to understand the working principle of the Auto PAN failover.Will it not trigger Auto failover when services are down but only if I reload the node? Is it based on IP reachability?
Also, wanted to know if I reload/stop ISE services in Primary MnT, will the Secondary MnT take over the Primary role.
Thanks and Regards
V Vinodh.
Solved! Go to Solution.
03-17-2016 03:18 PM
Hi Vinod,
Please see the following documentation for PAN autofailover and Health check functionality
Thanks
Krishnan
03-17-2016 03:18 PM
Hi Vinod,
Please see the following documentation for PAN autofailover and Health check functionality
Thanks
Krishnan
03-19-2018 07:56 AM
Hi Krishnan,
I got a request from Customer to enable PAN Automatic Failover in their network but the customer is using Medium type deployment Primary (PAN+MNT=1 Node) & Secondary (PAN+MNT=1 Node) & 3 x PSN separate Node.
Does Automatic failover work in this Medium type deployment ??
Thanks
Shivaprasad Gudsi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide