812
Views
0
Helpful
1
Replies
Problem with Data Access Permission for Endpoints

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2019 02:52 PM
Looking for help with a Data Access Permission issue.
The admin should only be able to add or delete an endpoint to a pre-defined endpoint identity group.
- Good - When the admin logs into ISE, they only see the endpoints from the specified endpoint group.
- Problem - When the admin creates a new endpoint and tries to assign the static identity group, there aren't any groups to pick from.
Labels:
- Labels:
-
Identity Services Engine (ISE)
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-30-2019 09:28 AM - edited 05-30-2019 09:29 AM
Please check this thread Community Thread about Identity Management Access
HTH
Regards,
Sathiyanarayanan Ravindran
Please rate the post and accept as solution, if my response satisfied your question:)
Sathiyanarayanan Ravindran
Please rate the post and accept as solution, if my response satisfied your question:)
