cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

1195
Views
0
Helpful
2
Replies
naoki_Japan
Beginner

Radius Server Priority

I aim to configure the radius server group, which works as fail-over not round-robin or load-balancing.

And configured as below.

 

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////

 

aaa group server TEST_Group

  server name A_radius

  server name B_radius

  server name C_radius

 

radius server A_radius

  address ipv4 10.10.10.1 ~~~~~~~~~

 

radius server B_radius

  address ipv4 10.10.10.2 ~~~~~~~~~

 

radius server C_radius

  address ipv4 10.10.10.3 ~~~~~~~~~

 

 

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////////

  

I expected that the priority order is

A_radius 1

B_radius 2

C_radius 3.

 

However, in contrary to my wish, the actual log output by the command "show aaa servers"  is

B_radius 1

A_radius 2

C_radius 3

 

 

How could I manipulate these priority as I expect ?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions
balaji.bandi
VIP Guru

If this is order -

 

I expected that the priority order is

A_radius 1

B_radius 2

C_radius 3.

 

May be due to some reason i am thinking Radius 1 one failed some reason, so the prority is changed here i guess (make sense ?)

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

2 REPLIES 2
balaji.bandi
VIP Guru

If this is order -

 

I expected that the priority order is

A_radius 1

B_radius 2

C_radius 3.

 

May be due to some reason i am thinking Radius 1 one failed some reason, so the prority is changed here i guess (make sense ?)

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

I found that A_radius server once failed, which caused the change of the priority.

THX

Create
Recognize Your Peers
Content for Community-Ad

ISE Webinars


Miss a previous ISE webinar?
Never miss one again!

CiscoISE on YouTube