cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1383
Views
105
Helpful
5
Replies

Read only user account to access FTD device using FDM

h.dam
Beginner
Beginner

Hello,

I'd like to know if it is possible to create a read only user account to access FTD 2130 using FDM (I don't use FMC)

I have tried to create a user by CLI: config user add xxx basic

This user account can only access the device via SSH but came out with error via HTTP/HTTPS.

For me, HTTP/HTTPS access is more pratical and comfortable than SSH, especially for the Policies.

If it is feasible, please show me the steps to do.

 

Thank you.

1 Accepted Solution

Accepted Solutions

@h.dam FDM doesn't allow creation of additional local admin accounts.

View solution in original post

5 Replies 5

Yes, I know Radius is a solution

But I'd like to use local user because it is more simple and doesn't need additional config.

What I want is using this local user account (with basic rights without enable access) to view the policies but has no rights to modify them.on FDM GUI.

@h.dam FDM doesn't allow creation of additional local admin accounts.

OK.

Thank you Rob.

 

Aref Alsouqi
Collaborator
Collaborator

Yes, FDM doesn't support creating multiple admin accounts for the UI, if you should decide to implement this with ISE then please check out this post of mine that shows you all the steps you need to implement it:

Creating Multiple Admin Accounts for FDM GUI Accesses (bluenetsec.com)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers