- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2022 01:22 PM
Hello,
I'd like to know if it is possible to create a read only user account to access FTD 2130 using FDM (I don't use FMC)
I have tried to create a user by CLI: config user add xxx basic
This user account can only access the device via SSH but came out with error via HTTP/HTTPS.
For me, HTTP/HTTPS access is more pratical and comfortable than SSH, especially for the Policies.
If it is feasible, please show me the steps to do.
Thank you.
Solved! Go to Solution.
- Labels:
-
Device Admin
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2022 02:18 PM - edited 02-24-2022 02:19 PM
@h.dam FDM doesn't allow creation of additional local admin accounts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2022 01:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2022 02:13 PM
Yes, I know Radius is a solution
But I'd like to use local user because it is more simple and doesn't need additional config.
What I want is using this local user account (with basic rights without enable access) to view the policies but has no rights to modify them.on FDM GUI.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-24-2022 02:18 PM - edited 02-24-2022 02:19 PM
@h.dam FDM doesn't allow creation of additional local admin accounts.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-28-2022 02:23 AM
OK.
Thank you Rob.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-28-2022 03:58 AM
Yes, FDM doesn't support creating multiple admin accounts for the UI, if you should decide to implement this with ISE then please check out this post of mine that shows you all the steps you need to implement it:
Creating Multiple Admin Accounts for FDM GUI Accesses (bluenetsec.com)
