Setup Guest WLAN using ISE 2.6

[yogesh.gaikwad1]

Hi,

I am trying to setup Hotspot Guest WLAN using the ISE 2.6. This is a fully new setup.

I am trying to search for a article / video which could somewhat match with the setup that I am trying to do.

Thus, if possible could someone please send me the URL of the video / article that I can refer as a configuration example for my setup?

In my setup I have dedicated 2 x ISE Servers SNS-3655-K9 appliance running 2.6 for Guest WLAN which mostly I will setup in HA, and these ISE boxes are located in DMZ. My Cisco 5520 WLC running 8.3.141 is located in the internal network with the guest WLAN interface terminated directly on the FW.

And what should be the ports opened on the FW which will allow communication between ISE server and WLC / Guest clients.

Below is a picture of what I am trying to do.

[Mike.Cifelli · Accepted solution]

Take a peek at these:
https://community.cisco.com/t5/security-documents/ise-guest-access-prescriptive-deployment-guide/ta-p/3640475
https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/115732-central-web-auth-00.html

I actually just went through a similar deployment using WLC 5520 with a ton of 3802i APs. Both of those links were helpful.
The default port for the portals is 8443. This is changeable in your portal settings and customization (Work Centers->Guest Access->Portal & Components-><Portal type>. You can use anything between 8000-8999. Good luck & HTH!