- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-15-2023 02:06 AM
I have an ISE node, ready to activate it's license. I read that syncing with CSSM will in basis send license status information, but also things like hostname, ip address and mac address to CSSM.
Is there a possibility to turn off sending this additional information to CSSM and if so how?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2023 06:56 AM - edited 06-20-2023 06:57 AM
Usually you need to generate the token from your smart account and use it to connect ISE to the smart account. I'm not sure if the MAC and IP addresses will be sent over, but I'm sure the host names and the serial numbers will be sent. I don't believe you have any control under what will be sent and not as there is not such control section on ISE and smart account portal that I'm aware of.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2023 02:48 AM
No one any idea?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2023 06:56 AM - edited 06-20-2023 06:57 AM
Usually you need to generate the token from your smart account and use it to connect ISE to the smart account. I'm not sure if the MAC and IP addresses will be sent over, but I'm sure the host names and the serial numbers will be sent. I don't believe you have any control under what will be sent and not as there is not such control section on ISE and smart account portal that I'm aware of.
