Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to start setting up a single DNAC node (without plans to converting it into a three node cluster).Following the install guide it mentions in the first part that giving the intra-cluster interface an IP address is mandatory, even though I ha...
I have an ISE node, ready to activate it's license. I read that syncing with CSSM will in basis send license status information, but also things like hostname, ip address and mac address to CSSM.Is there a possibility to turn off sending this additio...
Hi,I am looking to temporarily have my ise nodes activate their license via a proxy.Is it required to do this using an ad account via basic authentication? (I read it only supports basic authentication)Or can you leave this out and just have the ise ...
I have installed the SSM On-Prem 8 202212 ISO. I chose the DISA STIG profile instead of the default one.After booting up, i can SSH into the machine. However, the Web GUI isn't accessible. The firewall is allowing the traffic.I am using the https://i...
I just tried a "reset-config" on a ISE 3615 physical server, to change the default domain name. It is a standalone node ready to be tested, so no impact on any services. It promises me the following:isedemo/admin# reset-config% WARNING: This option w...
Hi, Thanks for the suggestion, but this didn't work back then.I logged a call with Cisco and the outcome of it was "we don't support your hypervisor platform, only VmWare, as is stated in the install guide. We can not help you further."The thing is, ...
I have the exact same question.Is a client blocked permanently after 3 attempts?If not permanently, then for how long exactly?How do you restore access for that specific client again?I know about the existence of the login block-for command, but i am...
Looking for a similar setup.I have a Catalyst switch which I want to connect redundantly to two Nexus switches. The Nexus switches connect to a firewall cluster.Is it possible to create an L3 port channel on the catalyst, a L2 VPC on the Nexus side, ...
An additional question:I am used to assigning a FQDN to each interface, but I understand that DNAC is only capable of assigning one FQDN for the entire box? Is this correct?Which is typically used? As I understand it's normally the VIP address, but I...
