06-15-2023 02:06 AM
I have an ISE node, ready to activate it's license. I read that syncing with CSSM will in basis send license status information, but also things like hostname, ip address and mac address to CSSM.
Is there a possibility to turn off sending this additional information to CSSM and if so how?
Solved! Go to Solution.
06-20-2023 06:56 AM - edited 06-20-2023 06:57 AM
Usually you need to generate the token from your smart account and use it to connect ISE to the smart account. I'm not sure if the MAC and IP addresses will be sent over, but I'm sure the host names and the serial numbers will be sent. I don't believe you have any control under what will be sent and not as there is not such control section on ISE and smart account portal that I'm aware of.
06-20-2023 02:48 AM
No one any idea?
06-20-2023 06:56 AM - edited 06-20-2023 06:57 AM
Usually you need to generate the token from your smart account and use it to connect ISE to the smart account. I'm not sure if the MAC and IP addresses will be sent over, but I'm sure the host names and the serial numbers will be sent. I don't believe you have any control under what will be sent and not as there is not such control section on ISE and smart account portal that I'm aware of.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide