01-17-2014 02:08 PM - edited 03-10-2019 09:17 PM
Hello,
I just upgraded to ISE 1.2 and lost access to my two repositories. This was expected.
I was able to get one of my repositories back by deleting and recreating it. I created it in the GUI and then ran the command "crypto host_key add "IP address of repo server".
When I deleted and recreated the second repo but still can't run a backup to it. I tried running the CLI command "Show Repo Backup" and I get a response " % SSH connect error". I have run the "crypto host_key add" command for this repo, also.
I searched the Cisco Forum and even Googled it with minimal results.
Any ideas?
01-18-2014 11:07 AM
What type of repository are you using? Solarwinds?
11-25-2015 06:47 AM
Hi,
i have the same error.
does there exists any solution to this problem?
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide