cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

315
Views
5
Helpful
1
Replies
Highlighted
Enthusiast

Switch Logging issue with IBNS 2.0 concurrent Dot1x and MAB

Hi community

I have a stupid issue with IBNS 2.0 while doing Dot1x and MAB concurrently.

Because for MAB devices the authentication using dot1x will fail since there is no supplicant responding, I alway get the following log messages:

...

%DOT1X-5-FAIL: Authentication failed for client (0080.64bf.abcd) on Interface Gi1/0/44 AuditSessionID 0A08161D00000ABC060A1234

...

Since we will have several thousend ports configured using both methods, I will get to much logs on my LMS. For sure I know I can lower the level from debugging or informational to any lower than 5, but I will miss these messages which are Important:

Dec 21 2016 16:07:27.019 CET: %SYS-5-CONFIG_I: Configured from console by abc123 on vty0 (10.17.1.2)


Any suggestions?


Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

This is not a question on ISE.

I found this on Cisco support forum which might help you.

Filter Syslog on Router | Network Management | Cisco Support Community

logging discriminator Config facility includes SYS mnemonics includes CONFIG_I

View solution in original post

1 REPLY 1
Highlighted
Cisco Employee

This is not a question on ISE.

I found this on Cisco support forum which might help you.

Filter Syslog on Router | Network Management | Cisco Support Community

logging discriminator Config facility includes SYS mnemonics includes CONFIG_I

View solution in original post

Content for Community-Ad