TACACS, CLI commands delay

[karen.melyan]

I used some SVI ip address to ssh to cisco switch. After I cteated new management vlan, then set IP address on interface of this vlan and try to connect to this IP address instead of previos IP, some deays appeard between Login/ Password promt and enable/conf t transition. I deleted previos SVI and changed agent IP address in ACS. Averything is worked but there are delays. Could you help me hat is the problem?

[minkumar]

Hi Karen,

  Could you please share the version of the box.

Minakshi (Do rate the helpful posts)

[Ravi Singh]

Please share the box detail as suggested by minkumar and also check that there is no network connectivity break between your devices.

[karen.melyan]

Thank you for your responces. I already found problem. My ASA firewall blocked new SVI IP address.

[Amjad Abdullah]

Exactly. When there are delays with the command that usually means the ACS is not reachable and it is most likely a connectivity issue between the AAA client and the AAA server (ACS).

Rating useful replies is more useful than saying "Thank you"