05-09-2018 07:53 AM
Hi,
In my network devices, I've configured SNMP creds for an IOS device. Is there a way I can test that the ISE nodes are successfully able to query SNMP on the IOS device?
Thanks
Tim
05-09-2018 03:30 PM
ISE does not have a test button for this. If debug snmp is on Cisco IOS device and/or TCPDUMP to capture the connections between ISE and NAD, we should be able to see the queries ~ 30 seconds after adding the SNMP configuration in the NAD and periodically based on the query interval setting.
05-11-2018 08:31 AM
Hsing,
Craig actually posted a helpful tip that I was trying to find about doing SNMP testing from ISE. If you go to Context Visibility->Network Devices you can select a switch and then run Port Config Status. That should kick off an SNMP query to the switch.
05-11-2018 09:17 AM
Thanks a lot, Paul. I think you meant this -- ISE - Test SNMP Access to a Node
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide