Testing Device SNMP config

[Tim Glen]

Hi,

In my network devices, I've configured SNMP creds for an IOS device.  Is there a way I can test that the ISE nodes are successfully able to query SNMP on the IOS device?

Thanks

Tim

[hslai]

ISE does not have a test button for this. If debug snmp is on Cisco IOS device and/or TCPDUMP to capture the connections between ISE and NAD, we should be able to see the queries ~ 30 seconds after adding the SNMP configuration in the NAD and periodically based on the query interval setting.

[paul]

Hsing,

Craig actually posted a helpful tip that I was trying to find about doing SNMP testing from ISE.  If you go to Context Visibility->Network Devices you can select a switch and then run Port Config Status.  That should kick off an SNMP query to the switch.

[hslai]

Thanks a lot, Paul. I think you meant this -- ISE - Test SNMP Access to a Node