11-23-2015 05:59 PM - edited 03-10-2019 11:15 PM
Hi I install ACS 5.- in vmware workstation. SecureCRT can login to the ACS and can show running-config through SSH. But I cannot login its web page. When I entered username and password(acsadmin/password
Solved! Go to Solution.
11-24-2015 02:10 AM
No, you need to set it via GUI only. CLI can be used to create cli admin accounts. Username for GUI and CLI are different.
Regards,
~JG
Do rate helpful posts
11-23-2015 08:01 PM
If this is a new setup then use password as default
UN = acsadmin
PWD = default
Change your password and login with new password.
Then you need to install license.
Regards,
~JG
Do rate helpful posts
11-24-2015 02:10 AM
Thank you so much for your reply. I am using trial version, and I do not have license. The below link is its protocol.
Change your password and login with new password.
I can login through SSH with username/password which I created when installing ACS. Apparently this username and password is different with the username/passord for web access. So do you think I can change the web's username/password or create new one through the SSH access? I tried it, but it did not work. When I tried to create new username/password, it is different with router
admin/admin(config)# username ABC password plain ABCD role ?
admin Specifies user with administrative role privileges
user Specifies user with read-only role privileges
https://ethernuno.wordpress.com/2014/04/01/install-cisco-acs-v5-4-for-gns3/
11-24-2015 02:10 AM
No, you need to set it via GUI only. CLI can be used to create cli admin accounts. Username for GUI and CLI are different.
Regards,
~JG
Do rate helpful posts
11-24-2015 11:30 AM
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide