08-08-2006 08:47 AM - edited 03-10-2019 02:41 PM
On ACS 3.3, I go to main menu,
I choose "Interface Configuration".
I make sure that "IETF RADIUS Attributes" is selected.
Then I refresh the browser, I go to "Group Setup".
On the top of the page, I attempt to pick "RADIUS" configuration. However it doesn't appear listed there.
As you can see on the attached bitmap, only few options are available even though I selected a number of them from User Interface as an exercise.
Please note that I already mapped a couple of Windows groups to the respective ACS Groups so
that I configure VPN and Wireless authentication.
Any idea what am I missing here ?
Why RADIUS configuration option doesn't show up ?
I already attempted to close and relaunch ACS Admin,
no progress.
08-08-2006 12:03 PM
Hi
Have you added a RADIUS device into network config? I guess you did because I dont think it would show up under interface config until you did.
Sounds like your ACS could be totally broken. Could be a re-install needed :(
08-09-2006 07:28 AM
In fact I don't recall I added a "RADIUS device";
Is that just a configuration or do I need to physically connect a special server there ?
Sorry for my ignorance, but I thought that the ACS server I am working on would be the provider of RADIUS services ? Can you clarify that ?
08-09-2006 07:45 AM
never mind. I got it working now.
AAA Server was not added correctly.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: