3209
Views
10
Helpful
2
Replies
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2021 05:47 PM
I would like to know how I can block a specific MAC on my Cisco Prime Infrastructure device. Is it possible?
Solved! Go to Solution.
Labels:
- Labels:
-
Appliances
-
Wireless
1 Accepted Solution
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2021 05:53 PM
- In the upper right-hand corner of PI, there is a search bar.
- Enter the MAC address of client PI have already "seen".
- Click on the MAC address and a different page appears which contains the "profile" of the MAC address.
- On the upper-right hand cornere of the screen is a "Disabled" option.
2 Replies 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2021 05:53 PM
- In the upper right-hand corner of PI, there is a search bar.
- Enter the MAC address of client PI have already "seen".
- Click on the MAC address and a different page appears which contains the "profile" of the MAC address.
- On the upper-right hand cornere of the screen is a "Disabled" option.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-17-2024 08:52 PM
Hi, if I have remove a client using Cisco Prime Infrastructure how do i re-enable or allow it back??
