cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
1224
Views
0
Helpful
1
Replies

Windows 10 not prompt for peap authentication on wire connection

Ahmed Al jawad
Level 1
Level 1

Hi Team 

  I'm new to Cisco ISE and doing some lab at home. I have ISE 2.1. did the ports and aaa config on the switch and port, when I connect the LAN the NIC showing it's trying to authenticate but it does not pop up for username and password, I did the steps below already on my laptop 

 

1- enable the auto wire config on the service 

2- I enable Microsoft PEAP and all other sitting under the NIC properties. 

3- under the NIC properties - an advance setting I enabled authentication mode " user authentication " 

 

 

help please 

1 Accepted Solution

Accepted Solutions

hslai
Cisco Employee
Cisco Employee

By default, it uses the Windows logon name and password. See clear that, you may follow some instructions found in the Internet; e.g. Step 9 in 

PittNet Wired: Configuring Windows 10 for Wired Publicly Accessible Network Ports | University of Pittsburgh

View solution in original post

1 Reply 1

hslai
Cisco Employee
Cisco Employee

By default, it uses the Windows logon name and password. See clear that, you may follow some instructions found in the Internet; e.g. Step 9 in 

PittNet Wired: Configuring Windows 10 for Wired Publicly Accessible Network Ports | University of Pittsburgh