I have a 6500 that is logging most activity from what I can tell. Acl entries are logged and I can see when login attempts occur. However, when an interface changes states there is no logging enrty.
Here is my logging config.
logging buffered 100000
no device-tracking logging theft
logging size 500
ip ssh logging events
ip access-list logging interval 10
logging source-interface loopback 0
logging host x.x.x.x
Thanks for any help you can provide.
Leo, thanks for your response.
If this is required its new to me. I have other switches that do not have this command that are logging interface down.