Hello everyone,I successfully added some devices to my prime infrastructure 3.9 using SNMP and SSH credentials. Now the devices are all in state "managed". But I am unable to change the device configuration or at least parts of it. I can change des I...
Forum Posts
Currently carrying out a refresh of my LAN devices moving to Cisco 3650 PS-S, when running SWIM from the software image management in Prime 2.1 I receive the following output: Image collection from sourceCollecting image with Protocol : SCPCollecting...
Meraki MS125-48 unable to do the virtual stacking. Physical stacking is not available. I didn't see the option to do the virtual stacking.
Hey colleagues I have PI of the latest version 3.9 and I'm currently working on creating a couple of maps. I have nice and clean floor plans which were scaled appropriately by using the scaling tool. I have columns in my building so I'm not sure how ...
We configured the cellular interface as follows:After some times later the IP adress assigned is downing, we also configured static route to ping some dumy IP like 1.1.1.1, but the result is same. interface Cellular0/2/0ip address negotiatedload-int...
Hi.We just found that all Cisco DNS (Cisco Prime Network Registrar 9.2) have notaccurate time and date.We have a internal NTP server and want our Cisco DNS to synchronize with it.So, is it possible to configure NTP on our DNS server ?If not, how to s...
Hi, I have a 6500 that is logging most activity from what I can tell. Acl entries are logged and I can see when login attempts occur. However, when an interface changes states there is no logging enrty. Here is my logging config. logging userinfologg...
Hi all, I've been working on a test setup with Business Dashboard and am running into some problems I can't seem to solve. The setup:Cisco Business Dashboard running in Azure on Ubuntu 16.04Network EquipmentRV340 router RV340-K9-G52x Business 250 Sm...
Hi, Can the result of "show crypto accelerator statistics " is IPsec throughput?If not, do we have a command to check that?ThanksLoc TA-FW# show crypto accelerator statistics Crypto Accelerator Status-------------------------[Capability] Supports...
Hi, We have two Cisco FPR-2110 set up site to site vpn. We tested without firewalls, the bandwidth between two sites is 500Mbps. But when we have the Firewall set up site to site vpn, the maximum speed we can have for a TCP Iperf3 test is 150Mbps. D...
Hello, I am new to Cisco Modeling Labs, I am trying to configure a topology with ansible through the DevBox, I can ping the hosts, but everytime i try to execute a playbook it gets stuck forever on "running the handler": I have looked around and may...
Resolved! SVI and Static MAC
Thought I would put this out there as I can't find an answer to this question. I will purposely not include all the history as I am asking a specific question. I am trying to add a mac-address command to a new L3 switch's SVI interfaces so the MAC...
Hi; Our customer has prime 3.3 version. How can we update to the 3.8 version as quickly as possible.how is the process
Добрый день Ребята настроил vrrp на cisco для bsc с bsc есть пинг до bvi но они не пингуют мой виртуальный гейт.В чем может быть проблема прошу помочь
Hi!I am new in networking and I am trying to setup this networking.I have supposed that I have these devices possible:layer 2 switch, 24 port FE and 2 ports GErouter, 2 ports FE, 1 wan port(it doesnt metter, fiber or any)In the router I have these ip...
