Add device, discovery device, configure and trobleshoot device

[nicanor00]

Hi

I am new on network management, and I installed cisco prime 1.2 this week

I need to perform these action on the ISE and on many catalyst switch

- Add device

- discovery device

- Monitor, configure and trobleshoot device

Which information should I ask to the network administrator (snmp version , ip address ...)

How should I perform thses 3 action (any step by step document should be good for me)

Regards

[AFROJ AHMAD]

Hi,

Chekc the below links:

http://www.cisco.com/en/US/docs/net_mgmt/prime/infrastructure/1.2/user/guide/gettingstarted.html#wp1069890

http://www.cisco.com/en/US/docs/net_mgmt/prime/infrastructure/1.2/user/guide/gettingstarted.html#wp1070951

http://www.cisco.com/en/US/docs/net_mgmt/prime/infrastructure/1.2/user/guide/gettingstarted.html#wp1070638

Thanks-

Afroz